(5) Close the cover; make sure it latches and that all the paper tabs
are centered in the paper tab slot.
(6) Draw out the safety cover to its stop (about 5 inches) and tear
40. How can you make sure that the 4" x 5" cut film you are loading will
be loaded correctly in the cut film holder(s)?
41. When loading a film pack adapter with a film pack, the safety paper
must be facing which way in the film pack adapter?
57 Setting Up Tripod. Remove the tripod from the tripod case and set it
up as follows:
a. Loosen the three leg thumbscrews (figure 6) and extend the three
telescoping leg extensions. Perform this operation with the telescoping
legs closed against the center post tube so that all three legs can be
extended approximately the same amount.
b. Tighten the leg thumbscrews to secure the telescoping legs in their
c. Loosen the leg lock handle and spread the telescoping legs away from
the center post tube to provide a firm stance. Tighten the leg lock handle
d. Loosen the tilt lock knob and place the top surface of the panhead
in an approximately horizontal position.