(1) General instruction for preparation.
(a) Block 1. Enter the organization designation of the unit to which
the equipment belongs.
(b) Block 2.
Enter the noun nomenclature and model of the equipment.
(d) Block 5. Enter current calendar date, on which equipment faults
were found, otherwise leave blank.
(e) Block 6. Enter the type of inspection or service to be performed
(operator's daily, monthly, or quarterly service, etc.).
(f) Block 7. Enter the TM number and date of the manual pertaining
to the item of equipment being inspected. When a change or changes to the
manual has/have been published, enter the manual number followed by "w/c"
and the latest change number. Enter the date of the latest change.
(g) Blocks 8a and 8b.
Upon completion of an inspection,
inspector (operator) will enter his signature, rank, and time signed.
(h) Column a. Identify each uncorrected fault entered in column c by
the TM item (sequence) number which identifies the prescribed check in the
preventive maintenance checks and services (PMCS) (table of the technical
manuals) used in the inspection.
(i) Column b. Enter the condition status symbol for all uncorrected
Status symbols are defined in paragraph 4-2c, TM 38-750 w/c 2.
Upon correction of a fault entered in column c, the person correcting the
fault will place his last name initial over the status symbol.
(j) Column c.
At the start of a duty day, the equipment operator
will enter the date in column 10c. Upon completion of the after-operation
check, the operator will initial column c to denote that no uncorrected
faults were found on the item of equipment.