Table 72. Troubleshooting (cont)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(cont)
Step 2.
Check to see that the back cover was not opened before
the film was rewound.
Exercise care not to open the back cover
before the film has been completely
rewound.
FLASH UNIT
10.
FLASH UNIT DOES NOT FIRE WHEN READY LIGHT IS ON AND SHUTTER RELEASE IS
PRESSED.
Step 1.
If flash unit is mounted on camera, check to see that the
flash unit is securely fastened to flash adapter, that PC
cord is connected to the hot shoe PC terminal (receptacle
on flash unit) and that adapter is pushed as far toward
the front of the camera as possible (figure 123).
If these conditions are not satisfactory,
attach the flash unit to the camera
correctly.
Step 2.
If flash unit is handheld, check to see that cords are
securely connected to camera and flash unit.
If these conditions are not satisfactory,
connect the cord properly.
11.
FLASH UNIT READY LIGHT DOES NOT COME ON WITHIN 1 MINUTE AFTER PLUGGING
UNIT INTO AC OUTLET.
Step 1.
Check to see that outlet has power.
If there is no power, use another outlet or
switch to DC operation (figure 124).
Step 2.
Check to see that ONOFF switch is at ON.
If switch is at OFF, move it to ON
position.
116
Previous Page
