21. When placing prints to be dried on the apron, you should maintain at
least how much distance between the prints?
a.
1/4 inch
c.
3/4 inch
b.
1/2 inch
d.
l inch
3-42 Stopping Procedures
a. Operate the thermostat control (figure 3-13) to the OFF position.
b. Operate the HEATER switch to the OFF position.
c. Allow the motor to run approximately 15 minutes to cool the drum and
dry the apron.
CAUTION:
Never leave the HEATER switch in the ON position when the
drum is not rotating.
This will result in scorching the
apron.
d. Operate the speed control to the maximum counterclockwise position.
e. Operate the MOTOR switch to the OFF position.
f. Operate the circuit breaker to the OFF position.
g. Unlock the print tray latch bolts from the feed table links (figure
3-15) and raise the print tray and feed table to the vertical flush position
(figure 3-14).
h. Secure the feed table to the drier frame with the latch bolts.
261
Previous Page
