2.
Processing Procedure
a. Press the OPERATE/STANDBY switch to "Operate."
b. Feed the exposed paper emulsion down into the machine. Always insert the paper lengthwise into the
machine for a more reliable transport.
c. In approximately 55 seconds your print will clear the dryer exit. If you do not plan to process any
more prints for at least 5 minutes, press the OPERATE/STANDBY switch to standby. Make sure that all prints
have cleared the machine.
3.
Wet Print Inspection
a. The Royalprint has a wet print inspection station that is located between the stop and fixer stages.
Access time for a 10-inch long print is about 21 seconds. After the print has been inspected reinsert it emulsion
down to complete the process.
b. To use this station, raise the hinged cover, figure 2-3, and prop it in place by raising the hinged
curved piece that is below it so that the edge of the cover catches the edge of the curved piece, as shown in figure
2-4. Prints will now automatically exit at this station due to the position of the inspection shoe actuator.
c. To reinsert a print, place it emulsion down, and feed the leading edge of the print into the slot just
beyond the inspection shoe. Feed it squarely into the machine so that the transport rollers catch the entire leading
edge of the print evenly, and begin moving it.
NOTE: If the print is not fed emulsion down, proper fixing of the print will not take place.
21
Previous Page
