represents the minimum height of the lettering you can use
for
a
viewgraph which the viewer can read from the distance stated.
For example, you must find the minimum height of the lettering for a
viewgraph when the projector is 14 feet from the screen and the farthest
viewer is 50 feet from the screen.
The dotted line on the chart in
figure 2-1 shows how you align the straight edge. First you place the
straight edge at the 14-foot mark on the left scale, and then align it
with the 50-foot mark on the center scale. As you see, the point where
it crosses the right scale is the 1/8-inch mark. That is the minimum
height of the lettering you could use for the viewgraph to meet both
distance requirements.
Now find the minimum height of the lettering for a viewgraph where the
projector is 30 feet from the screen and the farthest viewer is 60 feet
from the screen. You should find the minimum height of the lettering is
1/16 of an inch for a viewgraph used for these distance requirements. If
you did not find this answer, try again ensuring you align the straight
edge correctly.
is the 7 1/2- by 9 1/2-inch cutout portion. When preparing the master
for a viewgraph, you must ensure all the lettering and graphics stay
within the aperture area of a viewgraph slide mount.
One method to
ensure your work stays centered in the aperture is marking the center and
paper to the drawing surface.
Then place the tracing paper over the
graph paper attached to the drawing surface and attach it to the drawing
surface. Since the tracing paper is transparent, you can see the graph
paper through the tracing paper, which allows you to remain aware of the
limits of the aperture opening.
Even the best illustrators make mistakes. If you should make a mistake
when preparing the master, you do not have to make a new master. You
correct the mistake by cutting out the mistake and removing it, and then
inserting a section of tracing paper, using translucent mending tape.
Then all you must do is redraw the area where the mistake was.
c. The Diazo Machine (figure 2-4).
The diazo machine has four
sections: (1) printing, (2) developing, (3) cooling, and (4) exhaust.
(1) Printing section (figure 2-5).
This section of the machine
has four units: (1) light source, (2) reflector assembly, (3) printing
cylinder, and (4) feedbelt. At the start of the reproduction process,
you feed the original and a diazo foil or paper into the machine.
2-6
SS0530