22.
Up and away from the cut-film holder, (para 1-10b(6)).
23.
By locating the identification code notches on the film sheet, and making
sure that it is located in the upper right hand corner, prior to loading
the film into the holder, (para 1-10b(3)).
24.
The dark slide is inserted into the film pack adapter, (para 1-10c(1)).
25.
Set lens f/stop to widest opening, depress cocking lever, depress focus
button, (para 1-11a(1)(a)(b)(c)).
26.
Increase or decrease the distance between the front and rear carriage
(sec 1-11a(2),(3)).
27.
Loosen the center lock post knob and slide the center post up to the
desired height, (para 1-11a(4)(b)).
28.
Loosen the tilt lock knob and, with the tripod control handle, tilt the
camera to the desired angle, (para 1-11a(4)(c)).
29.
Rotate the spring-loaded pinion knob
until
the
desired
degree
of
correction is achieved, (para 1-11b(1)).
30.
Move the monorail bed with respect to the panhead, (1-11b(2).
31.
Slide the front or rear frame or both with respect to its carriage, (1-
11b(3).
32.
Front pivot lock knob, (para 1-11b(4)(a))
33.
Rotate the camera back (para 1-11b(6)).
34.
Remove the dark slide from the film holder, (para 1-11b(8)(e)).
35.
4x5-inch and 8x10-inch, (para 1-14).
36.
Lens assembly, (para 1-14a(1)).
37.
Rear frame, (para 1-14a(4)).
38.
Front movement mechanisms, (para 1-14d).
39.
Turn the two handwheels, (para 1-14e).
40.
3x4-inch, 4x5-inch, 5x7-inch, 8x10-inch, 11x14-inch, (para 1-14h).
79
Previous Page
