SECTION 3
STILL PICTURE, CAMERA SET KS7A
31
Setting Up Camera Set
Set up the camera set for operation as follows:
a. Load the filmholders (4" x 5" or 8" x 10") that will be required
(para 24a or b).
b. Load the easel with the object (para 26a and b).
c. Install the 4" x 5" or the 8" x 10" focusing back to accommodate the
required filmholders (4" x 5" or 8" x 10").
d. Prepare the converter (para 25a) and the light assemblies (para
25b) for operation.
_________________________________________________
32
Adjusting Size and Focusing
The camera set will produce copies the same size as the original,
enlargements of the original, or reductions of the original. The following
procedures may be used to obtain the required size.
a. Remove the lens cap from the front of the lens (figure 13).
b. Set the aperture lever (figure 13) to f/6.3. This setting will
admit the maximum amount of light and produce the minimum depth of field for
sharp focusing.
c. Press down on the press focus lever. The shutter will open and
remain open to permit focusing.
32
Previous Page
