EXERCISE
21. When setting up the print processor, the distance to a power source
should not be farther than: (select one)
a.
5 feet.
c.
7.5 feet.
b.
10 feet.
d.
3 feet.
22. When changing the drive gear from 60 Hz to 50 Hz, the hub on the new
drive gear must be facing __________________________________________________
_________________________________.
(complete statement)
23. A simple way to insure that the solution tray and the print processor
stands level is to use _____________________________________________________
_________________________________.
(complete statement)
39
a. General. The operator shall make certain that the print processor
is in satisfactory working order and that sufficient quantities of fresh
activator and stabilizer chemical solutions of the proper type are available
for the stabilization type paper used. The print processor must be leveled
(para 38c) each time it is moved to a new location.
b. Quantity of chemicals required. For the initial filling of the
solution tray of the print processor, 30 ounces of activator and 40 ounces
of stabilizer are required. After the solution tray is filled, a onequart
bottle of activator and a onequart bottle of stabilizer must be installed
to maintain correct levels of solutions in the solution tray.
c. Chemical life. The activator and stabilizer chemical solutions
shall be discarded and replaced with fresh chemicals after approximately
three hundred 8" x 10" in prints (or the equivalent area in other sizes)
have been processed, or after one week's use, whichever comes first.
202
Previous Page
