Lesson 5
INSTALLATION OF RADIO SET AN/GRC-213
OBJECTIVE
After completing this lesson, you will be able to install radio set AN/GRC-213 in a vehicle.
REFERENCES
This lesson is based on the contents of TM 11-5820-923-12 and other materials approved for US Army
instruction. However, development and progress render the text continually subject to change. Therefore, base
your examination answers on material presented in this lesson rather than on individual or unit experience.
22. INTRODUCTION. In this lesson, you will learn how to install the AN/GRC-213 onto a vehicular mount
for operation as a stand-alone radio set. This lesson is very important, because before you can operate this radio,
it must be installed properly.
23. INSTALLATION PROCEDURES. To mount the main components of the radio set, you should perform
the following:
a. First you should ensure that you have a complete radio set.
b. Check the mount to ensure that it is properly installed into the vehicle (refer to TM 11-2300-76-14-P).
c. Connect and latch the amplifier/coupler and receiver/exciter units together (see Figure 10).
Figure 10. Latching of receiver/exciter and amplifier/coupler.
35
Previous Page
