d. Place the latched units on top of the amplifier-power supply.
e. Slide the latched receiver/exciter and amplifier/coupler toward the rear of the amplifier-power supply.
There are cleats on the back of the AM-7152 amplifier- power supply into which the receiver/exciter and
amplifier/coupler should slide. If necessary, push them until they are fully seated.
f. Attach the two fasteners that are located on the front of the AM-7152 over the top of the catches on
the receiver/exciter and amplifier/coupler. There is one on each of the two units. (Refer to Figure 11.) Tighten
these fasteners until they are snug (finger tight) and the three units are securely latched together.
g. Now, slide this assembly into the mount and ensure that the guide pin holes on the rear bottom of the
AM-7152 line up with and fully engage the guide pins on the mount.
h. Attach the bottom fasteners on the mount over the two catches on the front of the AM-7152, and
secure them in the same manner as you did in step f.
36
Previous Page
