(4)
Slip the corners of the unnotched shorter edge of the cut-film
under the film slips (along each long side of the septum) and slide the
film completely into the holder.
(5)
Swing the bottom flap closed and hold down firmly.
(6)
Insert the dark slide into the slide channel so that the raised
identification dots face up and away from the cut-film holder.
(7)
Push the dark slide all the way into the cut-film holder; make sure
the end of the leading edge of the dark slide engages the groove along
the edge of the bottom flap.
(8)
Turn the slide hook over the end of the dark slide to prevent
accidental removal of the dark slide.
(9)
Load the reverse side of the
cut-film
holder
by
repeating
the
procedures in (1) through (8) above.
(10) Load additional cut-film holders by repeating the procedures in (1)
through (9) above.
c.
Loading film pack adapter (fig 1-32).
The film pack adapter may be
loaded under existing lighting conditions.
DO NOT expose the film pack to
direct sunlight during loading.
Figure 1-32.
Film Pack Adapter.
32
Previous Page
