(1)
Make sure the dark slide is inserted into the film pack adapter
before attempting to load.
(2)
Simultaneously press the two cover release studs to open the cover.
(3)
Unwrap
the
film
pack
and insert
the
film
into
the
adapter,
as
shown.
CAUTION: Hold the film pack carefully by the sides. Do not depress the black
safety paper cover or twist the metal frame; to do so may cause light to enter
the film pack.
(4)
Make sure that the film pack is inserted into the film pack adapter
with the paper safety cover facing the dark slide, and that all the paper
tabs rest in the paper tab slot.
(5)
Push the pack against the spring and drop into place.
(6)
Close the cover, making sure it latches and that all paper tabs are
centered in the paper tab slot and moves freely.
(7)
Pull out the safety cover tab to its stop (about 5 inches) and tear
it off.
REMEMBER, make sure that the dark slide is inserted into the
film pack adapted.
REVIEW EXERCISE
22.
To indicate there is unexposed film in a loaded 4x5-inch cut-film holder,
the film holder dark slide must be inserted so that the RAISED IDENTIFICATION
DOTS are facing _____________________________.
(fill-in)
23.
How can you be sure that the emulsion side is facing up when you are
loading sheet film into a film holder?
33
Previous Page
