LESSON 5
PRACTICE EXERCISE
ANSWER KEY AND FEEDBACK
Item
Correct Answer and Feedback
1.
A.
0C, 0M, 0Y
It is best to remove all filtration
from
the
light
source,
initially (page 4, para 4c).
2.
D.
10
Ten seconds is the recommended starting point.
As you may
notice, this is relatively high. This is because it takes more
change to notice an effect on reversal papers than with other
papers (i.e., Ektacolor or B/W) (page 4, para 4d).
3.
C.
Subtract cyan
When printing on reversal paper, if the print appears cyan, you
may either subtract cyan or add yellow and magenta. Generally,
if enough color already exists in your startup pack to allow you
to subtract, it is better to do so rather than add other
filtration (page 5, figure 5-1)
4.
C.
Subtract magenta
This is the proper action to take to correct a Cibachrome print
that is too magenta. You could also have added yellow and cyan.
(Remember, balancing color prints made from either Cibachrome or
traditional
reversal
papers
requires
the
same
corrective
actions.) (page 5, figure 5-1).
5-14
SS0514
Previous Page
