c. Connect the water inlet fittings to a 1/2inch water line with any
necessary pipe fittings. Install two 1/2inch valves in tandem in the water
supply line, one for shutoff and the other for regulating.
NOTE:
The two valves and all pipe fittings installed must be brass or
stainless steel to prevent rust and dirt from being carried into the
print washer.
FIGURE 32. Plumbing diagram for Washer EK1.
d. Make sure all hose clamps are tightened securely.
e. Hang the end panel in place on the right side of the washer.
221
Previous Page
