Figure 135. Logic symbol flow chart
To prepare a flow chart, start with the sketch or details on the VI work
order and draw a rough draft of the flow chart. Keep refining the rough
draft until you have a balanced, easytofollow illustration of the
process. The majority of the time, this process requires you to make
several rough drafts. Do not forget to consider the illustration ratio
of the chart. If it is the master for a 35mm slide or viewgraph, then
you must use a 2 to 3 ratio.
(3) Preparing a flow chart (final). With a final version of the
rough draft completed, you start the actual flow chart using a pencil to
draw the primary flow lines. Make sure you leave enough room for the
largest symbol and additional notes, lines, arrowheads, etc. Next you
add the symbols for the various steps of the process. Then check your
drawing to ensure it still presents the process as shown in the final
version of
1-42
SS0530