To disassemble and transport the radio set, use the following procedures:
Turn power off.
Remove the antenna and antenna shock mount (base) from the radio set.
Remove the antenna shock mount (base) from the antenna, and place the base in the space provided in
the transit case.
Starting at the tip (top end), fold the seven-section antenna, and place it in the transit case.
Remove the handset, and place it in the transit case.
Remove the battery pack from the receiver/transmitter-amplifier/coupler. Do not place the battery pack
in the transit case. Batteries must be removed from the battery case and transported separately.
ONLY BATTERY PACKS THAT ARE NOT ACTIVATED MAY BE PLACED IN THE TRANSIT CASE. AN
ACTIVATED BATTERY PACK MUST BE TRANSPORTED AND STORED SEPARATELY.
Place the receiver/transmitter-amplifier/coupler combination in the transit case.
Replace the transit cover, and fasten the four latches.
NOTE: The radio set is now ready for transport or storage.
13.
SUMMARY. In this lesson, you learned how to install and operate the radio set AN/PRC-104.
a. You also learned where the operator's controls and indicators are, what they do, and how to make the
required settings for operation.
b. Finally, you learned how to do an initial operational check of the radio set.
21
Previous Page
