c. Connect the water inlet fittings to a 1/2-inch water line with any
necessary pipe fittings. Install two 1/2-inch valves in tandem in the water
supply line, one for shut-off and the other for regulating.
NOTE:
The two valves and all pipe fittings installed must be brass or
stainless steel to prevent rust and dirt from being carried into the
print washer.
FIGURE 3-2.
Plumbing diagram for Washer EK-1.
d. Make sure all hose clamps are tightened securely.
e. Hang the end panel in place on the right side of the washer.
221
Previous Page
