Figure 1-22. Unloading the Camera.

Copy Photography I
Page Navigation
17

To unload the camera, you must

first press the rewind button 1 -

located to the left on the back of

the camera (fig 1-22).

Press the

extension shaft and hold it down

while, with the other hand, unfold

the rewind crank handle and turn it

in the direction indicated by the

arrow on the handle until all the

film has been wound back into the

film cassette. Then open the camera

back and remove the film cassette.

Figure 1-22.

Unloading the Camera.

1-6. THE ELECTRONIC FLASH UNIT HOOK-UP.

The synchronization cord for the

flash unit is permanently attached to the copier base, but it is detachable at

the camera. The proper connecting should be done in three simple steps. The

camera synch cord connection is located on the right side of the camera body

next to the lens bellows.

The camera connection is a

bayonet connection with two small

tabs (one on each side).

First,

line up the two slots in the cord

with the two tabs on the camera

connection (fig 1-23).

Figure 1-23.

Sync Cord Connection.