(7)
Adjust the kelvin temperature selector switch to the position at
which the Kelvin meter indicates the desired color temperature.
b. Light assemblies.
The light assemblies can be positioned either in
front of the easel or in back of the easel. Adjust the position of the light
assemblies as follows:
(1)
Loosen the knob located on the outside of the top of each light
assembly.
(2)
Remove the stabilizing bar from the stabilizing bar brackets.
(3)
Swing the light assemblies (mounted on the support arms) to the
front of the easel for copying opaque material, or to the back of the
easel for copying transparent material.
(4)
Align the light assemblies so that even illumination is obtained
on the easel.
(5)
Loosen the knobs located inside the top of each light assembly
and align the stabilizing bar brackets.
(6)
Install the stabilizing bar in the stabilizing bar brackets and
tighten the knobs (both inside and outside the light assemblies).
1-22. LOADING EASEL.
The easel can be loaded with standard size rigid copy,
with nonstandard size or nonrigid copy, or with a negative or a color
transparency.
a. Standard size rigid copy.
To load the easel with a standard size
rigid copy, proceed as follows:
(1)
Select the mask that matches the size of the copy.
(2)
Secure the mask (or masks) to the front of the easel.
(3)
Secure the copy within the mask with the clips provided at the
corners.
b. Nonstandard size or nonrigid copy.
To load the easel with nonstandard
size or nonrigid copy, proceed as follows:
(1)
Tip the easel to the right (horizontal) position.
(2)
Release the latch fasteners and open the easel.
69
Previous Page
