(3)
Place the copy over the scale on the mounting plate, or within
the border lines as necessary.
(4)
Close the easel and secure the latch fasteners.
(5)
Raise the easel to the vertical position.
c. Negative or color transparency. To load the easel with a negative or
color transparency of a standard size, follow the procedures in (1) below. To
load the easel with a negative or color transparency that is not of a standard
size, follow the procedures in (2) below.
(1)
Standard size.
(a)
Release the latch fasteners, open the easel, and remove
the plate and the sponge rubber padded mounting board.
(b)
Close the easel and secure the latch fasteners.
(c)
Install the opal glass in the rear of the easel; use the
easel corner clips.
(d)
Secure the negative or color transparency to the front of
the easel with the photographic mask or masks (a. above).
(2)
(a)
Follow the procedures in (l)(a) and (1)(b) above.
(b)
Install the opal glass in the front of the easel; use the
easel corner clips.
(c)
Tape the negative or color transparency directly to the
opal glass.
1-23. OPERATING PROCEDURES.
Setting up the camera.
Set up the camera for operation as follows:
a. Load the film holder (4x5-inch or 8x10-inch) that will be required,
(para 1-10 or 1-20).
70
Previous Page
