(5) Tighten the remaining ground pin screws.
d. Replacing Power Cable (fig. 1-9).
(1) Feed the base end of the cable (7) through the spring (2), the lamp socket cap (4), the lamp
house (11), and light cone (6).
(2) Fasten the white and black cable wires to the contact screws of the lampholder (5).
(3) Position the lampholder (5) and light cone (6) inside the lamp house (11).
(4) Fasten the green wire to the lamp house by threading the screw (8) to the lamp house and
connecting the wire to the screw. Tighten the screw (8).
(5) Hold the lampholder (5) against the top of the lamp house and slip the lamp socket cap (4)
over the top of the lamp house.
(6) Fasten the lamp socket cap (4) to the lampholder (5) with the nylon screw (3).
(7) Position the strain relief (1) on the cable (7) and slip the end of the spring (2) in the strain
relief.
(8) Insert the strain relief (1) in the hole in the lamp socket cap (4) and lock both halves in place.
Figure 1-8. Power cable, wiring diagram
14
Previous Page
