3-10 Operator's Controls and Indicators
Control or Indicator
Function
Illuminated start-stop
Starts or stops print processor.
switch (figure 3-2)
Indicator lamp
Glows red when print processor
is operating.
CAUTION:
BE CERTAIN THE ACTIVATOR CHEMICAL SUPPLY BOTTLE IS INSERTED
IN THE FRONT OPENING MARKED ACTIVATOR, AND THAT THE
STABILIZER CHEMICAL SUPPLY BOTTLE IS INSERTED IN THE REAR
OPENING MARKED STABILIZER.
AFTER INSTALLING THE VALVE
ASSEMBLIES ON THE CHEMICAL SUPPLY BOTTLES (PARA 3-6f), HOLD
THE BOTTLES ABOVE THE PRINT PROCESSOR, TURN THEM BOTTOM
SIDE UP AND QUICKLY INSERT THEM INTO THEIR RESPECTIVE
BOTTLE HOLES (figure 3-1). REFER TO PARAGRAPH 3-9b FOR THE
QUANTITY OF ACTIVATOR AND STABILIZER CHEMICAL SOLUTIONS
REQUIRED.
3-12 Operating Under Normal Conditions
CAUTION:
Do NOT operate the print processor if the switch cover
(figure 3-2) has been removed.
a. Starting print processor. Depress the illuminated start-stop switch
(figure 3-1). When the indicator lamp is illuminated, the print processor
is operating and ready for use.
CAUTION:
Always insert the exposed print (emulsion side down) into
the print processor. Do not touch the emulsion side of the
print before processing.
NOTE:
If the print processor is to be used intermittently, operate it for
one minute before inserting the first sheet of exposed stabilization
type paper.
b. Developing exposed stabilization type paper.
Place the exposed
print to be developed (emulsion side down) on the feed shelf, and feed the
print into the print processor as shown in figure 3-15.
Always feed the
exposed print into the
203
Previous Page
