Figure 1-18. Processor complete

Laboratory Procedures
Page Navigation
42

LESSON 1

Figure 1-18.

Processor complete

(1) Insert all paper lengthwise.

Always insert the exposed paper

emulsion side down.

Do not insert paper that is less than 5 inches in

length. All Kodak papers are supplied in sheets and are cut with the long

dimension running the long way of the roll. The same orientation should be

observed if sheets are cut by the user from larger sheets or from paper

supplied in a roll.

In this way, all sheets of paper can be handled the

same, with one of the narrow edges entering the process first.

IMPORTANT: Be sure the paper fed into the processor enters the

With 14-inch wide

paper, use the edge of the feed shelf to align the paper squarely

with the rollers. For paper widths less than 14 inches, center

the paper on the feed tray.

(2) Grasp the leading edge of the print as it emerges from the

processor and apply slight tension.

Failure to do this may result in a

paper jam, or excessive moisture on the trailing edge of the print.