LESSON 1
bellows for front to rear leveling.
Drain the water from the tray by
depressing this drain bellow.
Take out the solution tray and empty the
drain bottle. Replace the bottle and the tray.
(4) As shown in Figure 1-14, place the processing rack assembly on
the solution tray. Be sure the corners of the processing rack assembly rest
in the recesses of the solution tray.
After verifying the rack gear is
meshed with the base idler gear, snap the hold-down latch over the shaft.
Figure 1-14.
Rack assembly on the solution tray
(5) Assemble the Housing Assembly (fig 1-15) on the processor by
tilting the front upward and toward the rear of the processor, hooking the
Rod under the two brackets fastened at the rear of the processor base and
then lowering the front of the housing assembly.
38
Previous Page
