LESSON 1
on a stand or table 27 to 30 inches high.
Position the table near the
enlarger or printer being used to expose the paper.
Be sure to use the
recommended safelights since the paper is light sensitive.
a. Assemble and level the processor.
(1) Be certain that the two drain bottles are inserted into the base
of the processor as shown in Figure 1-13.
Using the tray location hole,
place the solution tray on the processor base. Insert the ends of the drain
bellows into the drain bottles.
Figure 1-13.
Processor base
(2) Level the processor (side-to-side and front-to-rear) by rotating
the leveling feet. Use a bubble level on the center partition to check the
side-to-side adjustment; span the width of the tray to check the front-to-
rear adjustment.
(3) Leveling can also be done by filling the front section of the
solution tray with water and adjusting the leveling feet until the water is
at the same height along the entire length of the center partition. Compare
the water level against the height of the flat surface near the front drain
37
Previous Page
