Figure 3-18. EL-5(1), drive roller assembly, exploded view
(2) Disassembly (fig. 3-18). Loosen the setscrews (1) on one of the drive tube collars (2). Slide
the drive tube collar (2) and the drive tube (3) from the drive roller shaft (4).
(3) Reassembly. Slide a new drive tube (3) and the drive tube collar (2) on the drive roller shaft
(4). Tighten the setscrews (1).
c. Replacement.
(1) Place the snub roller (8, fig. 3-13) in its brackets.
(2) Hold the snub roller and slide the drive roller assembly (7) with the output shaft of the motor
reduction gear case assembly.
(4) Install the bearing retainer (6) and secure it with the screws (4) and the lockwashers (50).
12.
Replacing the squeegee and drive rollers on the EL-5(2) through EL-5(5).
a. Removal
(1) Remove the screws (6, fig. 3-15), the lockwasher (7), and the bearing retainer (8).
(2) Hold the tension rod (10) and slide the drive roller (11) out through the adjacent hole in the
left bearing support channel (9).
56
Previous Page
